2021年12月10日 · If the tractor has no doors on the cab and it sits outside, this is very likely. Another possibility is the cable has rusted up. It is a cable and that's what cable controls do. Again, especially if the tractor has no doors on the cab (or is a 4-post ROPS) and sits outside. The plunger is the last thing that would rust up.

2015年1月4日 · I was wondering if anyone has replaced the RH crank arm assembly (p/n:64835C1) on a 986. I hit something hard while using the snowblower today and of course I broke the part that goes all the way through the tractor. I have a service manual and it says to drain Hy-Tran, remove IPTO, remove the broken part and replace with a non-broken part.

2016年6月24日 · Your battery or batteries are trash and need to be replaced, check the 2 wire plug on the alt. the wire going to the prong marked 1 should be only hot with the key on and at a reduced voltage, the wire going to the 2 prong should be 12 volts all the time. if they have been switched the alt. will go to un regulated output and full charge all the time. the wire going to 1 …

2018年8月31日 · D360 powered 886 vs 986 - pros and cons, parts availability on the D360. Discbine duty, square baler with kicker and wagons. Ocassional tillage with hay field refurb. Overall impressions between the 886 and 986. Thanks!

2013年6月20日 · Ac isn't blowing cold in the tractor we bought this spring. Low refrigerant light isn't on and the compressor runs all the time. I thought it might still be.low on refrigerant so to save some time I bought a can to put in it.hooked it up and the gauge said low pressure, so I put a little in, checked the gauge and it says its over charged.

2013年6月11日 · 30 weight around here and how about a twist to the story. Ran dairy, 150 head from 50's to the 90's...lots of year-round tractor work. So we ran 10-30 in the winter to make things easier to start up. The 986 we bought new and has over 8000 hours, never opened up yet just maintained. But the twist to the story was the 1845D Case skidloader we had.

2005年7月4日 · The dump valve (1/4" rod on left side of tractor, 7/16" wrench to adjust the nut at rear of rod) should be adjusted so that it is pulled out of the MCV 3/8" with the clutch completely depressed. (according to IH manual) The most important part of the dump valve adjustment is that it applies pressure before the tractor starts to move when ...

2005年1月25日 · This is an external adjustment and is done in conjunction with clutch pedal freeplay and the TA release valve adjustment.Can scan you the instructions if you need a copy. other possiblity is that you have tranny oil leaking onto the clutch and making it sticky, which means it is time to rebuild the pto gear stub shaft. this requires a tractor ...

2010年4月10日 · I am just wondering what it takes to replace the hyd pump on our 986. we have around 12,000 hrs on the original and it is getting tired. I would like to upgrade to the 15 or 17gpm pump, and was wondering what this would take. Haven't done this before, just thought I would see if anyone has any tips or advice they would pass along. TIA. Mark

2021年1月25日 · Here's a look under the seat from another 86 series shifting thread that's going on right now. Your high-low range is in the middle there as marked, and I think the one on the right is reverse (actually the left side of the tractor as sitting in the seat). On mine the flat plate had wallowed out where you see the bolt head.