2015年9月23日 · Both are pretty subtle, but I don't want repeats washing through the spaces created by the tremolo. Another option for those with delay that has an effects loop (for putting an effect on just the repeats) is tremolo on just the delay repeats. Try it. It sounds kind of cool. A fast, choppy tremolo sounds good for this application.

2008年8月17日 · But when Fender reissued the '65 Twin Reverb, they dropped the bias-vary tremolo in favor of the Deluxe Reverb's pre-PI tremolo. The same circuit, give or take, is found in the silverface Vibrolux. There are some other variants, some with a single section of a 12AX7 doing all the work, some with a full tube/two sections.

2021年1月1日 · Bias vary tremolo is going to depend a lot on how hot your tubes are biased and how loud you're playing. The VC tremolo is also bias vary, but on the second gain stage of the preamp, so it also kind of depends on how loud you're playing, or how hot your signal is.

2019年1月12日 · Also, amp tremolo often changes the sound of the amp, sometimes making it sound like it has slightly more overdrive, is darker or whatever. A tremolo pedal doesn't really do that and it sounds just as good IMO. Tremolo on some Fender amps is …

2016年1月17日 · This mod suggests to entirly disconnect the tremolo circuit from the signal path by replacing the tremolo intensity pot with a switchabe pot (spst). One side effect with this mod is a noticable click and a volume difference between tremolo on and off using the new spst pot.

2020年5月27日 · This filters the tremolo signal. He states: "The "Tremolo High Pass Filter" is a fifth order high pass filter which removes tremolo thumping that can be created in the tremolo oscillation. Each RC network stage rolls off at a slope of 6dB per octave at 32Hz which creates a very steep filter roll off.

2008年10月7日 · +1 This is the correct solution for the Princeton. I have reduced the 1M tremolo depth resistor to values as low as 270K with great results - much deeper tremolo, like the small tweed and brown tremolo amps. Don't worry, this change doesn't hurt a thing.

2018年1月31日 · There are normally 3 caps tied to your tremolo circuit. two .01s and one .022. Pull a .01 and replace with a .022uF. That will slow it down. More intensity: You will find a 1M resistor in that circuit, try a 220K. That will highly increase the intensity. you can use a 470K too.

2011年9月27日 · i speak from somewhat limited experience. i needed a guitar with a trem for a record i've been working on and bought a cheap xaviere blem jazzmaster copy for $169 a couple months ago. i was planning to replace the trem with an actual fender one, but the darn thing stays in tune perfectly and has a cool sound so i've just left it stock. it feels ...

2024年1月24日 · Most bias vary tremolo circuits work by modulating power tube bias. The Valco tremolo circuits modulated the preamp tube bias. A little different and harder to “kick start” the oscillation. That’s why a Valco trem control begins at its …