2016年1月5日 · The canister purge solenoid — also referred to as an EVAP canister valve — is responsible for “purging” the EVAP system by acting as the switch that allows the vapor into …

2016年11月18日 · The job of the canister purge valve, also known as the canister purge solenoid, is to prevent vapor produced by the fuel cell from releasing into the atmosphere. This …

2020年3月17日 · Step 4 - Evap Purge Valve is located behind the Throttle Body on the back side of the engine. Depress vacuum hose clamp lock and remove vacuum hose. Loosen 10mm hex …

2024年12月10日 · Replacing the purge valve up front is quite easy. And takes about 10 min at most. The part is $14-20 on rockauto. This bad part causes the hard start after filling up. As for …

2016年10月3日 · The purge valve may be leaking vapor by it and into the engine when you are refueling. This will cause the engine to get fumes into the engine when it should not be getting …

The defective canister purge solenoid is detached and removed. The new canister purge solenoid is installed and connected. The engine is started and checked for any vacuum and fuel vapor …

2021年1月8日 · There's a new design purge valve (at least for Gen 1's). The one on my 2017 was replaced a year ago by Chevy dealer "under warranty." I didn't have the "hard to start" issue, …

2016年1月14日 · Normally the canister purge solenoid lasts the life of the vehicle, but it can wear out from time to time. If the canister purge solenoid starts to go out, the Check Engine light will …

2022年8月7日 · I went to replace my Purge Valve Solenoid located under the engine cover on my 2010 Traverse, which we purchased used. When I tried to disconnect the hose from the valve …

2018年8月13日 · Ordered a new valve from Rock Auto and changed it out in about 10 minutes time, one handed. Left hand was out of commission due to an accident that cost me a finger. I …