what are the symptoms of failing ignition control module?
2009年10月30日 · If you suspect ignition module failure, pull the center wire off the distributor cap, stick a spark plug in there, rest the plug on the motor (so that it is grounded) and have someone turn the engine over a couple times. You should see a ton of spark. If nothing, the plug is well grounded, and no engine codes, you can start thinking ignition ...
Symptoms of a failing Ignition Control Module?
2013年3月19日 · remove module , replace coil with a standart ignition coil , install a condensor at the coil minus [ going to pointes ] ground body of condensor with a wire / hose clamp . you will have to modifie wirring to coil , ignition to plus of coil , and minus to pointes .
replacing ignition control module and coil - Jeep Enthusiast Forums
2011年1月4日 · This was an issue for my 86 CJ7 last week. I replaced the module with a stock module from napa and bought the gold coil as well as a new coil connector (the little black horseshoe shaped plastic connector that connects to the top of the coil) this afternoon. Jeep is running like a champ again. all in all it cost me $63. good luck
88 4.2 YJ Ignition Module questions | Jeep Enthusiast Forums
2011年10月29日 · Grounding the ignition module like 4x said made a big difference in how mine ran. I put a new cap, rotor and plug wires on mine when I bought it so put off the Team Rush upgrade for a long time, but it made a big difference too when I finally did it.
HELP! How to tell if 4.2 Ignition control module is bad?
2009年1月2日 · My jeep ignition has been missing for a few days. Today I went and did the team rush mod, rebuilt the carb, and it still runs bad. Does anyone with the 4.2 have experience with the ignition control module going bad? How do I test it. What are the symptoms of a bad one. My jeep is nuttered and has ran great ever since the nutter until now. Help.
Symptoms of a failing Ignition Control Module
2007年11月20日 · But I've got a suspect Ignition Control Module failure, no start at all, no spark what so ever, crank position sensor fine, new coil, dizzy cap and rotor, still nothing. I'm after a ignition module for a 2.0L 8v 1992 190... Any help appreciated. Freddie
How Can I Test Ignition Control Module (ICM)??? - Jeep Enthusiast …
2009年5月8日 · Of course no Autozone in my area knows how to test anything (not a problem in my hometown) so I couldn't test the coil (no multimeter or book). By the way there was no spark. I bit the bullet and bought a $45 coil and put it in, nothing. I did some research and found the ignition control module in the distributor and took it out.
Where is the Ignition Control Module??? - Jeep Enthusiast Forums
2012年3月15日 · There is no ignition control module on a 98. That went away after 1990. Try swapping the ASD relay located in the power distribution center under the hood with another relay. They are all of the same part numbers, so swapping is not an issue. The computer (PCM) is located under the hood on the fender.
Symptoms of a Bad Ignition Control Module? | Mercedes-Benz …
2014年6月29日 · The symptoms for my car was sometimes it would start, and sometimes it would not. When it did start one day, I wiggled the green wire at the ICU, and the engine would cut out and then come back on. I replaced the original ICU with a smaller, replacement version from Autohaus,AZ. Part # on their box is 002 545-26-32. Part # on the ICU is, 13 138 ...
What Are Symptoms of Defective Ignition Control Module (EZL)?
2024年4月18日 · It was very sudden as if I had turned off the ignition and removed the key. I tried to crank the car and it cranked normally but the engine would not start. Finally, my car started and ran normally after three hours of the car not being driven. The hood was open to let the engine compartment cool. Could the ignition control module, EZL, be ...