2022年1月19日 · Typically that little switch gets broken by failure to position the leaver with a wedge or a similar spacer while installing the brake lever. Best fix is to depin it from the harness. A PIA job for sure, especially if you have heated grips. Good luck!

Learn how to replace a brake light switch on a Harley, using a shim to hold the brake lever contact tab away from the switch during assembly.

2024年6月26日 · Locate and understand the front brake light switch near the brake lever assembly. Carefully remove and replace the old switch, tracking wire placement. Test the new switch by squeezing the front brake lever for light illumination. Verify proper installation, wiring, and functionality for safe braking on your Harley Davidson.

Remove the brake lever snap ring, pin and lever. Use your finger to actuate a release the switch and watch brake light function. How to fix: Mostly this is due to the misalignment between the master cylinder and switch housing. Loosing and adjusting the …

2023年11月5日 · Follow these steps to troubleshoot the front brake switch: Start by loosening the handlebar clamp to allow for adjustment. Move the master cylinder and lever to ensure proper alignment with the switch housing. Tighten the clamp and check if …

2010年11月11日 · The problem I had was that the brake lever was barely touching the switch and causing the brake light to flicker off and on. Here is a simple fix. 1. pull the brake lever back and place something in between the housing and lever. I …

2023年8月18日 · I recently got into a 16 dyna Street Bob and the front brake light stays on. I need to replace it. Let me preface: I have already checked the master cylinder side plunger, cleaned it. I have checked the fitment between brake lever mount and switch mount, its lined up. Ive replaced the spring inside of the switch.

2024年1月17日 · Various issues can cause Harley Davidson brake light problems, including a faulty brake light switch, damaged wiring, blown fuses, or burnt-out bulbs. How To Troubleshoot Harley Brake Lights? Begin by checking the brake light bulb and fuse; if intact, test the brake light switch with a multimeter for continuity and inspect the wiring for any ...

A smaller, yet critical, component to the brake system is the brake light switch which illuminates the tail light when the brakes are engaged. When these switches fail, accidents happen. Fortunately, replacing these switches is well within the grasp of the DIY motorcyclist.