2018年11月11日 · Assembelled X-Axis of Arduino Drawing Machine, End Plates of the X-Axis were horizontal 8mm drilled to support two X-Axis rods Each X-Axis’ Upper-End Plates were drilled and bearings were attached on nut, bolt and washer to work like a pulley for the belt

2017年5月7日 · The Crazy Engineer’s Drawing Robot or Arduino GRBL CoreXY Servo Drawbot is a CNC based drawing robot. It is open source and open hardware based project. It uses Arduino UNO (Atmega328p) as the brain of the robot and a special GRBL firmware for G-Code Interpretation and motion control.

2017年12月7日 · INTRODUCTION to Arduino Drawing Machine v1. The Crazy Engineer’s Arduino Drawing Machine or Arduino GRBL CoreXY Servo Drawbot is a CNC based drawing robot. It is open source and open hardware based project. It uses Arduino UNO (Atmega328p) as the brain of the robot and a special GRBL firmware for G-Code Interpretation and motion control.

2018年11月11日 · Learn How to Make an Arduino Drawing Machine – Fast Precise- H-Bot – CNC Shield V3 – A4988 – 17HS1538 Stepper Motor – Micro Servo 9G By Crazy Engineer , 6 years November 11, 2018 ago Arduino Computer Numerical Control (CNC) DIY Project

2020年11月28日 · Introduction. In this tutorial, we will learn how to interface a light sensor/photoresistor (LDR / Light Decreasing Resistance, or light-dependent resistor, or photo-conductive cell) with Arduino / Atmega328p.

2020年5月11日 · Motor Driver boards are widely used in Arduino, Raspberry Pi and other Mechatronics projects. This project / Driver Board is compatible with any microcontroller or microprocessor with 5V Logic. The focus of the project is to use cheap and readily available components to make a Motor Driver Module / Board with a L298 Driver IC.

Microcontroller Section of DIY Arduino UNO v1.0; DIY Arduino UNO v1.0 Schematic Design PCB Layout. Similar steps are followed for the PCB layout as it is followed for schematic capture. Eagle CAD was used initially and later the file is imported into KiCad. A 3D view / render of the PCB is also available in KiCad.

2018年12月29日 · Port C has 7 Port Pins [PC0…PC6]. But in the Arduino UNO board PC6 is used for ~RESET (Reset Pin). So effectively we can use 6 Pins as GPIO. Port D has 8 pins [PD0…PD7]. In the Arduino UNO board, we can use all 8 pins effectively. Let us look into the Schematics of Arduino UNO and see how the pins are mapped.

2018年12月24日 · How the GIPO work in Arduino? How the IO Ports work in AVR ATmega328p? What are the modes of IO Port in Arduino/ATmega328p? GPIO Input Output Modes. High Impedance / Floating / Hi-Z / Tri-Stated; Input Mode with Pull-Up or Pull-Down; Output Mode with Open Drain; Output Mode with Push Pull; High Impedance / Floating / Hi-Z / Tri-Stated

Projects - Tutorials - DIY Guides related to Embedded Software, Electronics, Remote Control Vehicles, CNC, Mechatronics, DIY Projects, Woodworking and more!