2004年11月14日 · UPDATE: CV Boot Clamp/Strap Replacement (pics) I have a 2000 UZJ100 rig w/ 110k miles on it. After reading several posts of people having issues with there CV boots leaking after doing an OME lift with and or without Slee's drop kit, I decided to take a look at my boots before my lift and drop kit showed up this week.

2007年12月3日 · The inner CV boot angle/geometry has changed making the boot hole/opening point a little downward causing the leak on that minute gap. *All other band intact and dry, just this one. Discovered this last week and started to work on it before dusk.

2019年11月13日 · Most shops do not clean outer CV, they just add some new gease and boot it. DIY, tend to clean with brake fluid, which does not get very clean IMHO. I too have done a number of reboots. I've found it take seven 10 minute soakings & flushing with solvent to get the outer CV tulpe clean.

2005年3月25日 · 17. Tape axle splines with electrical tape to protect boot installation. Install boot. *I chose to use 3/16” smooth band worm-drive hose clamps found here: McMaster-Carr part #5574K25 4” to 4-3/4” and part #5574K16 1” to 1-5/8” 18. Slide inboard boot over shaft, then cage, note cage direction (smaller end goes first). 19.

2007年11月4日 · You just need a re-clamping of small inner CV boot clamp. NAPA carries them. Just ask for small CV boot clamp. 30 minute job. If you've lifted rig. Slee diff drop always a good idea. But diff drop or not. Lifting done on broken-in front drive shafts (AKA CV). The inner CV tends to fail in time.

2017年7月26日 · Due to my steering knuckle oil seals failure the cv axles had begun rusting themselves into the splines of the hub making removal a frustrating experience, until I drove a 5/8” bolt through the axle puller flange onto the face of the cv axle.

2005年6月23日 · If you are concerned about the balancing (act), you can actually take two smaller clamps at put them together to have a "balanced" clamp (one screw at each side of the axle). Concern would of course be that you get another "thing" sticking out that could potentially get hung on a branch or a...

2024年3月8日 · CV Boot Clamp Pliers, Single Ear Hose Drive Shaft CV Axle Boot Clamp Removal and Installation Tool Compatible with Toyota Lexus etc OEM 09521-24010 https://a.co/d/i1ycWeZ You will thank me. Driving a Land Cruiser always makes me want to take the long way home.

2020年12月14日 · These CV boots have been completely re-designed to work with high angle applications, such as lifted vehicles. They are made from silicone material, making them very resistant to the heat and friction created w/ high angles. Kit includes 1 boot, 2 clamps, and CV joint grease. 2 kits are needed...

2022年3月29日 · Likely, the factory FDS were replaced due to improper wheel bearing service which can damage them and or minor FDS boot clamp weep. Boot clamp weeping CV grease is common. Wherein, all that is needed is a new clamp. But many shop replace the FDs needlessly instead. They end up putting on junk aftermarkets or manufacturer FDS,