2010年9月22日 · I would have to say the best toilet flange to use is the Barracuda Toilet Flange. It is water tight, completely seals that area, and it has drain holes for any water to go back down the drain. It also has a flat bottom which allows you to adhere it to the floor, thereby making it not only water tight, but the strongest flange available today.

2010年7月16日 · Today I successfully removed the old cast iron toilet flange and am left with a 4" cast iron pipe. The top of the pipe will be about 1.25" below the level of the finished floor. I am looking at a couple of PVC/ABS replacement flange from Oatey and Sioux Chief. Which one would you guys...

2018年11月28日 · Dimension H (top of flange to floor): 1.5" (the flange had spacers between it and the floor, and i have removed those, and the flange can go up and down about 2-3" both ways just fyi) Dimension D: 8.5" - This was from the top of the flange with a straight edge, down to where the pipe was sitting at the bottom

2016年1月7日 · FWIW, the design position of a toilet flange is on TOP of the FINISHED floor, and tight to it with no gaps. If yours is not there, you may need two wax rings if it is low. Depends on how low it is. Builders often put the flange in during rough-in, prior to the finished flooring to save money and time. Millions installed like that.

2015年11月24日 · Put the flange bolt in placed and secure them to the flange with those extra nuts. The will keep the bolts upright and in place while you lower the toilet. Having another set of eyes would help also. If it was a new toilet, I would put the bowl down first then mount the tank.

2023年4月5日 · Doing bathroom renovation and with cement board and tile flange will be low the thickness of cement board and tile. What would be the best way to seal the toilet to the flange? Better to use spacer and wax? 2 wax rings? Or are the non wax ring seals better...

2006年6月11日 · flange Forget the drill business and just take a 3/4" cold chisel and whack the flange from inside to out, right at the outside of the lead but from the inside of the joint. Then pry the broken flange off and cut the lead into with a wood chisel and pull it out with your channel locks. Should take less than 60 seconds normally.

2018年2月23日 · I was putting in a new toilet and discovered the previous owner had the old toilet attached to a plastic flange that was not attached to a very rusted out cast iron toilet flange. This was beyond my scope so I had a plumber come out. They tried to fit an adapter inside the pipe but it was too big.

2007年1月11日 · I'm installing two toilet flange extenders to raise the flange height above the new ceramic tile floor. I put a bead of DAP 100% silicone caulk between the new and old flanges and screwed them down. This was the indoor/outdoor variety caulk. Is there any difference between it and the kitchen and bath 100% silicone caulk?

2012年3月16日 · 1. The "notches" that the bolts were installed in WERE the best way to mount the toilet. Using the slots usually insures that the flange will break. 2. You did NOT do yourself any favors by removing the broken section. 3. You could, and should, have used crescent shaped "spanners" under the cracked piece. 4.