Oct 1, 2018 · To anyone who is concerned: Under my current network setup, I am unable to access my modem setup pages. My Default Gateway is 10.0.0.1, which is the IP address of my Orbi. If I attempt to access the last known modem IP address of 192.168.1.1, I get a time out (Firefox) or a page not found (Edge)...

May 17, 2023 · Hey, Just purchased 2 x 3650 switches. I need to set things up to replicate my config from the old 3750s. I've got the switched powered on, ethernet plugged into the back MGMT port and other end into my laptop. I've disabled wifi too. Ethernet shows up, but can't access https://10.0.0.1 I did this...

Feb 26, 2012 · Solved: Hi all, Router A sh run int loopback 1 Building configuration... Current configuration : 63 bytes ! interface Loopback1 ip address 10.10.0.1 255.255.255.0 sh ip int brief Loopback1 10.10.0.1 YES NVRAM up up Loopback2 10.10.1.1 YES NVRAM up

Sep 20, 2018 · Bonjour, J'ai configuré mon routeur comme c'est demandé par Netgear. Cependant, je ne comprend pas pourquoi je ne peux pas accéder au retour en 192.168.1.1 car ça appartient au modem au lieu du routeur. Donc je voulais savoir si c'était normal que le routeur n'ait pas pris cette adresse mais qu'il...

Mar 8, 2013 · IF the host 10.0.0.12 actually has its own public IP address you could just open port TCP/444 for this host on the "outside" interface ACL. It wouldnt need any port forward as the above NAT configuration already makes it possible to contact the device using that public IP address on any port PROVIDED that the ACL rule for it exists.

Jul 26, 2021 · I am having an issue with port forwarding. I have two laptops running off the same Netgear router (@10.0.0.1) - one at 10.0.0.5 and the other at 10.0.0.12. The apache server on 10.0.0.12 is listening on port 8080. Here is how I have this set up in my router I can connect directly to the server ...

Mar 8, 2013 · The translation defined that the host 10.0.0.12 was actually behind the "outside" interface and that it would be translated to the "interface" IP address of "inside" It would have been accessible from behind the "inside" with TCP/444; After the change the NAT should operate so that. The translation would still be done for the host 10.0.0.12

Oct 4, 2022 · Dear Community Members, It's been a time since I've been on the forum, anyway I must first describe my current problematic equipment: 3 x ReadyNAS Duo v2 running firmware 5.3.13 1 x New PC running Windows 10/11 I used to have an old WinXP PC which worked very well with my RNDuo v2's but unfort...

Apr 11, 2022 · This is a bit puzzling. The show run in a previous response shows an encrypted enable password. If you were able to make the config changes to get SSH to work then it would seem that you had the correct enable password.

Jun 29, 2022 · Hi Community, the best of internet !!!! Dear all, let me to open this new topic We have a project to change the OSPF areas of a Network of switches/routers currently all in area Zero (0). The network was growing and now is the time to put things as they should be. We want to know what is the ...