2019年3月23日 · SUPER DREADNOUGHT -our new flow bench. Post by David Vizard » Sat Mar 23, 2019 4:20 pm. This is Flow ...

2024年10月12日 · I don’t know if can still be had but a buddy had a Isky 256 super cam in his 400 tow rig pulling an enclosed car trailer. It worked very well once headers where put on and the carbs secondary metering rod tips where sanded down .004” If I …

2025年1月7日 · SpeierRacingHeads wrote: ↑ Tue Jan 07, 2025 3:26 pm Other than Super Stock, is there any classes out there that run flat hoods and SBC's? I'm going to design and have made a 23º SBC manifold that is low profile, like a Victor E, that will fit under a flat hood.

2024年11月11日 · Factory metering block. Dead on. I’m running the 112-9 throttle body with short T-slots, so even at 1.5 turns of the curb idle screw, she idles strong at 1000 rpm with no slot showing. I do have my idle mix screws at 2.5 instead of the 1-1/4 with the universal 112-117 throttle body with super long T slots.

2024年12月22日 · of degrees difference in .020 and .050 be when it would be considered super aggressive and on the edge ? Solid 55MM Roller w/ .937" lifter w/.850 wheel . Any comments would be appreciated . If more info. is needed, speak. Thanks , Mark H.

2016年9月11日 · For Sale: Complete Jerico DR4 Drag Race 4 speed with Hurst Super Shifter. Gear ratios are 3.08, 1.93, 1.34, and 1-1. This is the more common (and preferred) wide gear model. Has the good roller tail housing. 2nd gear uses a 6 lug dog ring for smoother shifts. 3rd and 4th have good 10 lug dog rings. 32 spline output shaft.

2023年7月1日 · In building some Super Stock small block Chevy stuff in 20+ years past, we would get the same heads done by two different places ... Dave Layer intake ports and Steve Sanchez exhaust ports; (no brazing). Those engines always made great power.

2024年10月26日 · The super vic is reserved for the bigger engines. We have run the super vic on snarley 289's before but they were strictly top end power producers and cars were usually faster around track with smaller intakes that were properly ported. [/quote] Bill builds some very fast, winning engines. [/quote] Understood ...

2008年6月15日 · I cleaned up the runners some and used Edelbrock A/B epoxy to make extended runners like the Super Victor has. It ended up with more bottom end and throttle response than the RPM Air Gap intake. I have a similar engine somewhat. 11:1 400 SBC, ported Sportsman IIs, BG 800, 1 3/4" Super Comps.

2012年2月22日 · super victor ii (4000-8000 rpm) This all new small-block Chevy manifold is designed to work with modern high flowing 23° heads on large cubic inch applications. The runner area at the plenum is 25% larger than our Super Victor #2925, and the port exits are sized for use with a Fel-Pro #1206 intake gasket.