2020年12月23日 · Change to the Klipper directory (cd ~/klipper/) and run the config tool (make menuconfig). Select the following in the menu: Select the following in the menu: Uncheck Enable extra low-level configuration options .

Haven't installed Klipper myself yet as there is a setup process. The main difference between the Marlin Approach vs Klipper is that Marlin processes the gcode file and controls stepper drivers, etc. With Klipper the main device running Klipper (raspberry pi, laptop, etc) does that gcode processing which can include input shaping while being ...

2023年3月1日 · As one that runs both a Marlin and a Klipper printer (Ender 3 and BiQu Hurakan), theres a lot more going on for the Klipper printer, but both are perfectly usable for general usage and printing. However, there's no doubt that the Klipper has a lot more features going on, due to the add-on board necessary to run the various services (CB1 in my ...

I have a Qidi Q1 Pro running their weird locked-ish firmware of klipper. I have to run input shaping every time I change to different types of filament for reasons like PLA is on the spool holder but ASA is in my dryer so it changes the located of the filament which drastically changes the input shaping accelerations and type from mzv to zv sometimes.

2023年1月13日 · Klipper: Klipper is a firmware that leverages the computing power of a computer (the S905X in this case ...

2023年6月22日 · Klipper can help you and your machine produce beautiful prints at a fraction of the time. This is not an official Klipper support channel and poorly moderated so ymmv. Check Klipper out on discord, discourse, or Klipper3d.org

2022年7月16日 · Klipper can help you and your machine produce beautiful prints at a fraction of the time. This is not an official Klipper support channel and poorly moderated so ymmv. Check Klipper out on discord, discourse, or Klipper3d.org

2019年11月7日 · Your Klipper steps are in the printer.cfg in the [extruder] subsection called "step_distance" (Use WinSCP to access and change this) Repeat until it is extruding 100 mm perfectly, obviously this isn't the best method but it's what's worked for me so …

2021年2月23日 · I used rotation_distance that was set in the config for my printer that I worked off of while setting mine up to use in the final calculation to tune it to my actual extrusion. I only installed Klipper last night and have been tuning since then, seems promising though.

2021年12月9日 · Your first comment isn't right because Klipper docs say clearly that Input Shaping screws with your PA, then PA screws with your flow. So this comment is the correct order. What I found from experience is that if your filament is dry, you don't really need to change retractions per filament.