2009年4月5日 · Re: Roll and Tip Interlux Brightside Paint the biggest thing is your sanding. make sure the surface is smooth. a foam roller is fine but do many thin coats. don't try and put on too much with the roller. i used a badger hair paint brush to tip with and had great results. sand between coats. two to three coats should be sufficient. i did my boat ...

2007年12月6日 · Re: Pettit Easypoxy vs. Interlux Brightsides QC, I think you have two products mixed, as far as application. I've used both Pettit and Interlux (one parts) with great success. They are interchangeable, in my book, as long as you are talking about "one part" epoxies. My local, Ace Hardware, will "tint" anything I bring them. Been there.

2012年4月12日 · Interlux does suggest not to buff Brightside in their tech data and in their online help section. I repainted our 35 year old trawler for the second time 3 years ago. The boat stays in the water and we buff and polish every year - the paint still looks fresh.

2010年6月15日 · 6.) Will apply Interlux Brightside White paint using the roller and brush/tip method, will be two of us painting so one will brush and the other will tip never letting the leading edge dry. I plan on putting two coats down so will sand in between and clean up with Interlux Brushing Liguid 333 before starting a new coat. 7.)

2010年1月22日 · Re: Rustoleum Topside, Pettit Easypoxy, and Interlux Brightside.. any diff in durabil Durability is relative. Generally speaking all of the paint brands you mention are quality products. The durability of the paint is going to depend on how well you take care of it after it is applied. It also depends on how well you prep.

2008年1月19日 · Re: Interlux Brightside on hull You can leave the Brightside on the bottom. Just go over it with the bottom paint, of your choice. I have done so with no issues. Interlux makes many bottom paints, as mentioned. I doubt you will have any issues. I would suggest going to the Intrrlux website for further tips/clarification.

2011年4月19日 · Used Interlux Brightside on the topside of my Starcraft. The interlux people say that after the last coat of paint, no wet sanding or buffing is recommended. What are you guys opinions on this. p.s. Also, if I were just to buff it, would I just dry buff it, or spray some water on it?

2020年5月16日 · The original surface was Brightside that I put on (with roll/tip) about 7 years ago. I sanded everything down to the original gelcoat/previous primer, then added a few coats of primer, sanding in-between coats as Interlux recommends on their instructions. I believe I used 220grit after the final coat of primer and before the first layer of topcoat.

2009年6月15日 · Re: Interlux Brightsides Over GelCoat? 1) Dewax- with solvent get it extra clean 2) sand with 220 lightly Make any repairs to get the surface smooth 3) Prime 4) sand primer 5) paint good to go this is a oversimplified version of steps for paint. Prep is key to a good job. The idea that gelcoat cannot be painted is a myth.

2006年12月17日 · Re: Spraying Brightside Paint I sprayed my boat completely out doors with no cover. I used 2 part urathane. sprayed it early in the morning before the sun got too warm. wetted the ground around the boat to keep the dust down. it came out better than it would in a booth.