2020年7月27日 · So even though I toned out the vvel position sensor wires to the vvel ecu pins and got 0 ohms, it appears that pin 5 on the sensor (white wire) which is a ground has a break somewhere. I dunno how it toned to 0 ohms last time but toning it out to the engine grounds yielded infinit resistance on my multimeter where as pin 2 which is also a ...

2009年7月27日 · The VQ37 VVEL most definately has an intake camshaft, and a throttle plate that works like any other car. Now, like most newer cars, the TB is of the drive by wire type, with no physical cable connecting the accel pedal to the TB. The VVEL mechanism is on a jack screw, that adjustes lift within a defined area of sweep using a small motor.

2020年1月8日 · I have a working theory that the issue isn't the VVEL module or relays at all but is in fact the IPDM module supplying inconsistent power to the VVEL module and destroying the components. Im going to go over my IPDM with a multimeter if replacing the relays and VVEL module again (+ better waterproofing) doesnt work.

2014年8月6日 · DTC No. Trouble diagnosis name (Trouble diagnosis content) DTC detecting condition Possible cause P1606 VVEL CONTROL MODULE (VVEL control module) • VVEL control module calculation function is malfunctioning. • VVEL EEP-ROM system is malfunctioning. • VVEL control module DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING 1.

2014年4月5日 · This is a pic of the VVEL assembly section with the solenoid removed, dont do that, LOL! It will just make your life easier. This is the VVEL assembly internally, there are two allen/star bolts that connect to the VVEL cam that will need to be removed to get the entire assembly off the back of the head. Cam caps, keep track!

2022年11月20日 · The VVEL system is great however there will be a point where you will reach max power for lift even though the cam can go farther it wont make any more power due to duration. The duration on the VHR controls both cams per bank equally unlike the HR which would be separate.

2021年11月11日 · Anyway, the VVEL control shaft position sensor is integral to the VVEL Actuator assembly which is replaceable and not part of the VVEL mechanicals under the rocker covers. The service manual outlines procedure for replacing the actuator assembly and Nissan sells them in the parts department. They are around $600 from Nissan parts stores online.

2010年9月19日 · Nissan Variable Valve Event and Lift (commonly abbreviated as "VVEL") is an automobile variable valve timing technology developed by Nissan. Nissan VVEL was first introduced to the US market in late-2007 on the 2008 Infiniti G37 Coupe sporting the new "VVEL" VQ37VHR Nissan VQ Engine (VQ37VHR motor specs: 11.0:1 CR, 95.5mm bore, 86mm stroke ...

2021年10月7日 · I checked the VVEL Control Shaft Position Sensor voltage with Cipher and was getting a voltage reading of 648 for both banks. Following the instructions in the manual, I loosened the mounting bolts and adjusted the VVEL Control Shaft Position Sensors to a voltage of 499-504 using Cipher as the tool to visually adjust the voltage.

2017年11月15日 · My 370 is stock, 110k miles. It was taken into the dealer after it wouldn't rev above 2k. It also wouldn't go above 5 mph. The cel came on. The problem was intermittent. The nissan dealer says 3k for ecm and vvel module replacement. Im cool with that because the parts are very cheap if they are used.