Download and install Nuvoton NuMicro ICP Programming Tool, and connect as shown in the figure below 2. Open the ICP Tool, specify the UI language and target chip, and then click Continue , as shown in Figure 7.

This chapter describes operation modes of the ICP Programming Tool and Nu-Link dongle. 3.1 ICP Programming Tool Modes The ICP tool supports “online” and “offline” programming mode. 3.1.1 Online Programming Mode If the “Offline programming mode” option in Figure 4-14 is unchecked, ICP Programming Tool

Home > Software and Tool > Software Tool > Programming Tool. Enter the Email address you like to share Email Name Validate Code: Submit Cancel Evaluation Board. General. NuMicro 8051 Evaluation Board; NuMicro M0 Evaluation Board; NuMicro M23 Evaluation Board; NuMicro M4 Evaluation Board; NuMicro M7 Evaluation Board ...

ICP Tool Revision History Aug 3, 2023 Page 2 of 16 Rev. 3.13 ry TABLE OF CONTENTS 1 Revision History ..... 3 2 Supported Debugger and Programmer ..... 9

2024年7月31日 · The software tools developed by Nuvoton, called NuTool, include: general tools (PinView, PinConfigure, ClockConfigure, CodeGenerator, USB to Serial Port), programming software (ICP, ISP, Nu-Link Command), and specific …

2021年5月31日 · When using the ICP tool, offline programming or online programming can be used for encrypted programming of NUC505. The user must first switch the NUC505 to ICP mode before the ICP tool is connected.

The Nu-Link Adapter supports ICP (In-Circuit Programming) based on the SWD (Serial Wire Debug) signal interface. The user can employ the NuMicro™ ICP Programming Tool to update chip firmware for mass production. The Nu-Link Adapter also supports the third-party development tools, such as Keil RVMDK, IAR EWARM, and CooCox CoIDE.

2021年6月30日 · Renamed "ICP Tool" to "NuMicro ICP Programming Tool". Fixed a bug to update locked chip in offline mode. Supported to check update from network. Supported SPI flash.

First, click ICP Tool “Start” button to program the data to SPI flash of Nu-Link. (For some part numbers, target device must be connected to Nu-Link in this step.) Next, you can do offline program without ICP Tool, just press the button on the Nu-Link adapter (see Figure 3-1).

2017年3月23日 · ICP stands for "In Circuit Programming". PC runs the software “NuMicro ICP Programming Tool” through the SWD (serial wire debug) port of Nu-Link circuit to update the internal APROM, LDROM, Data Flash and User Configuration Word of the target chip.