This video is an introduction to stress and strain, which are fundamental concepts that are used to describe how an object ...

Using 3D process models to predict the impact of mechanical stress on yield and performance. With the semiconductor industry ...

In the initial stage of strain, the response is linear in the stress and may be described by Hooke's law: s = E e. E is an elastic constant, Young's modulus. A material exhibiting this behavior over ...

Few, if any, have recorded stress-strain relationships in these investigations. Although it might be possible to calculate, from these indirect measurements, the slope and area of the dynamic ...

If the Poisson's ratio of the material if positive, then tensile/compressive strains in the x-direction produce compressive/tensile strains in the y- and z-directions, as shown below. Negative Poisson ...

A U.S. foreign service officer blamed the Trump administration's "cruel and harmful shutdown" of USAID for threatening the ...

The hypothesis used in developing the stress and strain in the shaft is that all points on a cross-section of the shaft experience the same angle of twist. The angle of twist for a section of length L ...

If there are no shear stresses present, there is no fluid deformation, and the behavior of a fluid is described by the bulk modulus relating the pressure and the compression strain. In the presence of ...

This paper closes by discussing the possible conditions under which members of support systems may transfer or exacerbate stress effects rather than alleviate them. En este articulo, el modelo Demanda ...